|
Be careful when taking the top of the case off. The wires attached to the |
Once the battery is out of the case, locate the positive and negative wires. |
|
Use a set of pliers to pull and detach |
Now detach the positive wire from the battery.
|
Sometimes the wires are attached |
|
Sometimes you may come across |
The top of the case should now be completely released from the old battery pack. |
In case the thermistor needs to be replaced, use a soldering gun to release the old thermistor. |
|
Once the Old thermistor is detached, prepare the new thermistor by |
New thermistor should look like this.
|
To attach thermistor, first solder to |
|
|
|
|
|
After you solder the positive wire, solder the negative wire. |
Next, locate the positive and negative tabs on the new battery pack. They will be marked for your convenience. |
Begin by sliding the positive wire clip over the positive tab on the battery pack. | |
![]() |
![]() |
![]() |
|
Use pliers to squeeze the clip tightly onto the tab. | Use a soldering gun and solder to secure the clip to the tab. | Repeat the same steps with the negative. Slide the clip over the negative tab. | |
![]() Use pliers to squeeze the clip tightly onto the tab. |
![]() Use a soldering gun and solder to secure the clip to the tab. |
![]() Inspect your work. Make sure the wires are in the correct place and secured. |
|
![]() Before you put the case back together, push the thermistor wire through the hole on the top of the battery pack to eliminate the risk of pinching the wires. And you're done! Screw the case back together! |